68
Use this setting to sound an alarm when the receiver battery voltage drops dangerously low. VIB
(vibration) that vibrates the transmitter at the same time can also be set.
Method
① Select "RX-BATT" from the telemetry
screen with the Jog key.
② Open the setting screen by
pressing the Jog key.
① In the RX-BATT screen state, select
(ALARM) from the menu with the
Jog key.
② Select the "ACT" by pressing
the + key or – key.
① In the RX-BATT screen state, select
(LIMIT) 0.0V from the menu with
the Jog key.
② Select the voltage by pressing
the + key or – key.
Selection range：
3.5V 〜 8.4V
● When you want to set 5.0V, press the
+ key and – key simultaneously.
① In the RX-BATT screen state, select
(VIB) from the menu with the Jog
key.
② Select the "TYP1 〜 TYP3" by
pressing the + key or – key.
Calling the setting screen
Alarm set
Alarm voltage set
Vibration set
● Setting receiver voltage alarm.
RX-BATT
(ALARM) (VIB) (LIMIT)
DN▶INH ▶OFF ▶ 6.0V
SPEECH▶ INH SW▶ NULL
0.0V
MIN/MAX=
0.0V / 0.0V
DN (down) shows than an
alarm is generated when
the voltage drops below
the set voltage.
＋ －
or
＋ －
or
TYP 1
TYP 2
TYP 3
"VIB" types
＋ －
or
To Next Page
Loading...
