GAI-Tronics Elemec3 - Configure System Zones and Audio; Configure System Zones; Configure Audio Sources

Pub. 42004-550C
Elemec3 Console Manual—Version 3 Page 4 of 109
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550C.docx
07/21
5) Define the System’s Zones
Action
Screen
Add zones
Zones (on page 67)
• Enter the zone description.
• Assign the audio outputs to the zone:
• Monitor Output
• Aux Output
• Assign the amplifier channels to the zone.
• Assign relay outputs to the zone.
• Assign relay groups to the zone.
• Assign logic flags to the zone.
Zone Configuration → Zone Builder screen
(on page 68)
6) Configure the Background Music Source
Action
Screen
• Select the audio input source (Aux 1–5).
• Select the zone where background music will play.
• Select the time interval for amplifier testing.
Playback Audio → Background Music
(on page 72)
7) Import Sound Files for Pre-Recorded Messages
Action
Screen
• Browse and select an .mp3 file.
• Import the .mp3 file it into the configuration file.
Playback Audio → Import MP3
(on page 71)
8) Define System Tones
Action
Screen
• Select an .MP3 sound file for a system tone (1–7).
• Enter a description for a system tone (1–7).
• Select an .MP3 sound file for the “TICK TONE”.
• Set the play volume for each system tone.
Playback Audio → System Tones
(on page 71)
9) Add Messages
Action
Screen
• Add a new message. Enter a message description.
Playback Audio → Playback Audio
Configuration
Add Message (on page 70)
• Event Setup—Select automatically create events and the
manual and/or auto event check boxes.
• Select the default zone for the message to play in.
• Configure automatic logic flag setup.
Create New Message (on page 70)
• Select the .mp3 sound files to include in the message.
Message Builder (on page 72)