GAI-Tronics Elemec3 - Event Control and Chaining; Event Cancel and Acknowledge; Event Chaining

Pub. 42004-550C
Elemec3 Console Manual—Version 3 Page 80 of 109
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550C.docx
07/21
External Event Options
Figure 89. External Event Options
Source Specific ?—selected and disabled because all external audio sources need an input contact to
trigger the source since they do not have PTT buttons.
Source—available sources are enabled in the LIVE AUDIO SOURCES, LIVE AUDIO CONFIGURATION pane
(on page 59).
Event Cancel
Specifies how the system cancels events:
Require Cancel—requires cancelling the event from an access panel button before the system can clear
it.
Cancel Mode:
• Manual—an access panel must cancel the event.
• Auto—cancel the event manually or it will cancel automatically after the Auto-Cancel Delay expires.
• Auto-Cancel Delay—delay (seconds) for the event to cancel.
Event Acknowledge
Ack Required—an access panel must acknowledge the event before it clears.
Mute on Ack—Acknowledging an event mutes the audio for the Max Mute Duration, on the GLOBALS
panel on the SYSTEM PROPERTIES screen (see the Global Settings section).
ACK MODE:
Manual—requires event acknowledgement from an access panel.
Auto— manually acknowledge the event or configure it to automatically acknowledge after the Auto-Ack
Delay expires.
Auto-Ack Delay—delay (in seconds) for the event to auto-acknowledge.
Event Chaining
Event chaining allows events to initiate other events in the system. There are three options for linking
events: None, Direct, or Conditional:
None—no event chaining takes place.