GAI-Tronics Elemec3 - Add System Events

Pub. 42004-550C
Elemec3 Console Manual—Version 3 Page 5 of 109
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550C.docx
07/21
10) Add System Events
Action
Screen
• Add an Event
System Events → Add Event (on page 74)
• Enter an event description.
• Select the Event type:
• live audio
• playback
• record/playback
• silent
• external
Add Event (on page 74)
For Live Audio Events:
• Select the audio source of the event.
• Select pre and post announcement tones.
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
Event Builder (on page 75)
For Playback Events:
• Select the message to play.
• Select the playback mode (repeat, continuous).
• Select the cancel and acknowledgement options.
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
Event Builder (on page 75)
For Record/Playback Events:
• Select the audio source of the event.
• Select pre and post announcement tones.
• Select the playback mode (repeat, continuous).
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
Event Builder (on page 75)
For Silent Events:
• Select the cancel and acknowledgement options.
• Select the output and logic flags to activate.
Event Builder (on page 75)
For External Events:
• Select the audio source of the event.
• Select the cancel and acknowledgement options.
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
Event Builder (on page 75)