Gima PC-3000 - 12.1 Default Remote Screen

70
ENGLISH
Chapter 12 Screen Display for Remote Observaon
12.1 Default Remote Screen
Press the DISP key to shi screen to Observing Screen when seng Disp2 as “Obsev” in System Setup screen, as shown
in Figure 13.1.
Figure 12.1 Screen display for remote observaon
Operaon Instrucons:
ECG lead: press it to shi the ECG monitoring circulatory among Ⅰ, Ⅱ, and Ⅲ, aVR, aVL, aVF and V.
Alarm silence: press it to enable or disable the alarm silence funcon.
Freeze: press it to freeze the ECG waveform and perform manual S-T segment analysis. Double press this key
within 2 seconds to lock or unlock the operaon of all other buons (except power switch) on the front panel.
NIBP: press it to start or stop NIBP measure.
DISP: press it to shi the display to the Main Screen.