When registered barcodes number reach the
maximum 100, a warning message “DATA
FULL” appears on the top bar with a warning
sound composed of a short beep followed by a
long beep indicating no available space for new
barcode to be imported.
After configuring the barcode page, switch to
the MANU or AUTO mode with READY status
first. Use an USB virtual com port-compatible
barcode scanner, which plugs into the USB
Host Port on the front panel, to scan the
matching barcodes and the screen will jump to
the corresponding test page or the
corresponding test will launch automatically,
depending on the AUTO TEST setting.
To Next Page
Loading...
