EasyManua.ls Logo

Hisun HS800UTV - Checking the Engine Oil Level

Hisun HS800UTV
362 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE AND ADJUSTMENT OF THE UTV
- 91 -
(11.5 kg/cm2, 163.57Psi)
Maximum: 1,480Kpa
(14.8 kg/cm2, 210.50Psi)
·Crank over the engine with the electric starter (be
sure the battery is fully charged) with the throttle
wide-open until the compression reading on the
gauge stabilizes.
NOTE:
When cranking the engine, ground the spark plug
lead to prevent sparking.
4. Install:
·spark plug
18 Nm-20Nm (1.8 m · kg, 13 ft · lb)
5. Lower the cargo bed.
CHECKING THE ENGINE OIL LEVEL
1. Place the vehicle on a level surface
2. Remove:
·driver seat
·passenger seat
·console
Refer to “SEATS” in chapter 5.
3. Check:
·engine oil level
Oil level should be between the maximum
and minimummarks.
Oil level low
Add oil to the proper level.
NOTE:
Do not screw the dipstick in when checking
the oil level.
Recommended oil
Follow the left chart.
NOTE:
Recommended oil classification:
API Service “SE”, “SF”, “SG” type or equivalent
(e.g. “SF—SE—CC”, “SF—SE—SD” etc.)
NOTE:
Do not allow foreign material to enter the
crankcase.

Table of Contents

Related product manuals