CHASSIS
- 222-
SPECIFICATION OF WHEEL AND TYRE
Wheel hub
Dimension
Tyre
Dimension
Tyre
Pressure
（Kpa /PSI）
Front
Wheel
12×6.AT
25×8-12
(NHS)
140/20
Rear
Wheel
12×8.AT
25×10-12
(NHS)
140/20
• Since wheels and tyres are crucial to the vehicle
operation, inspection for tyre pressure and profile
depth is necessary.
• To ensure maximum security and longer life
expectancy of the wheel, please periodically inspect
the tyre pressure and profile depth. Insufficient tyre
pressure can result in not only intensified wearing of
the tyre but also instability during the course of
operating the vehicle (such as hard turning).
Excessive tyre pressure can also reduce the friction
force between the tyre and ground, causing spinning
or lose of control. Therefore, please ensure the tyre
pressure strictly complies with figures shown in the
chart above.
• Before operating the vehicle each time, please
check if profile depth of the tyre is over worn, which
might result in spinning, instability, lose of control
and other potential security risk of the vehicle.
To Next Page
Loading...
