CHASSIS
- 191-
STEERING DRIVE AXLE
CHECKING AND SERVICE THE STEERING
DRIVE AXLE
• bearing ①
• circlip ②
• oil seal ③
• cross axis ④
• Inspect the cross gimbal turn agility with no
stagnation.
If does, dismantle and check the cross axis,
bearing ,and the bearing hole on the cross
gimbal fork whether have wear and corrosion, to
instead the parts based on the check.
NOTE:
Install the cross gimbal, daub the lithium
grease on the surface of the bearing.
• Inspect the transmission shaft whether have
crack and distortion. If it does, instead the parts.
To Next Page
Loading...
