Hisun HS800UTV - Assembling the Rear Brake Caliper

CHASSIS
- 210-
WARNING:
Replace the caliper piston seals and dust
seals whenever the brake caliper is
disassembled.
ASSEMBLING THE REAR BRAKE CALIPER
WARNING:
• All internal brake components should be
cleaned and lubricated with new brake fluid
only before installation.
Must use DOT4 Brake Fluid
• Replace the caliper piston seal and dust
seal whenever a brake caliper is disassembled.
1. Install:
• caliper piston seal ①
• dust seal ②
2. Install:
• brake caliper piston ①
Turn the brake caliper piston clockwise until
section ⓐ of the brake caliper piston is level
with the surface of the brake caliper body.
NOTE:
Align an end ⓑ of the groove in the brake
caliper piston with the punch mark ⓒon the
brake caliper body.