Hisun HS800UTV - Changing the Coolant

MAINTENCE AND ADJUSTMENT OF THE UTV
- 96 -
·coolant level
The coolant level should be between the
minimum level mark ○
a
and maximum level
mark ○
b
.Below the minimum level mark
Add the recommended coolant to the proper level.
CHANGING THE COOLANT
1. Remove:
Front faceplate
·coolant reservoir cap ① ；
·Disconnect coolant reservoir hose ②；
· Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is used
instead of coolant, check and if necessary,
correct the antifreeze concentration of the
coolant；
·Use only distilled water. However, soft water
may be used if distilled water is not available.
2. Drain:
·coolant
(from the coolant reservoir)
3. Connect:
·coolant reservoir hose
4. Remove:
·coolant drain bolt (water pump) (along with the ①
copper washer)
.