MAINTENCE AND ADJUSTMENT OF THE UTV
- 95 -
WARNING
:
Use a cleaning solvent which is designed to
clean parts only. Never use gasoline or low
flash point solvents as they may cause a
fire or explosion.
b. squeeze the excess solvent out of the element
and let it dry.
NOTE:
Do not twist or wring out the element. This could
damage the foam material.
c. Squeeze out the excess oil.
NOTE:
The element should be wet but not dripping.
4. Install:
·air filter element
·air filter case cover
NOTE:
To prevent air leaks make sure that the sealing
surface of the element matches the sealing
surface of the case.
·console
·passenger seat
·driver seat
CHECKING THE COOLANT LEVEL
1. Place the vehicle on a level surface.
2. Remove front faceplate
3. Check:
·start the engine, warm it up for several minutes,
and then turn it off.
·coolant level
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
To Next Page
Loading...
