Hisun HS800UTV - Checking the Fuses

MAINTENCE AND ADJUSTMENT OF THE UTV
- 123 -
NOTE:
Constant amperage chargers are not suitable
for charging MF batteries.
3. Install:
• battery
• Connect:
battery leads
NOTE:
First, connect the positive battery lead ①, and
then the negative battery lead ②.
• Check:
battery terminals Dirt
Clean with a wire brush.
Loose connection Connect properly.
• Lubricate:
battery terminals
• Install:
battery case cover
• Close the hood.
CHECKING THE FUSES
NOTE:
Always turn off the main switch when
checking or replacing a fuse. Otherwise, a
short circuit may occur.
1. Remove:
• lift the hood up.
• battery case cover
2. Check:
• fuses
a. Connect the pocket tester to the fuse and check it
for continuity
NOTE:
Set the tester to the “Ω × 1” position.
• blown fuse
.