Hisun HS800UTV - Page 4

- 3 -
Removal…………………………………………………………………………………… 26
Installation………………………………………………………………………………… 27
Interference fit …………………………………………………………………………… 28
Seal replacement………………………………………………………………………… 29
STORAGE……………………………………………………………………………………… 30
Storage area selection…………………………………………………………………… 30
Preparing the motorcycle for storage …………………………………………………… 30
Returning the UTV to service…………………………………………………… 30
TROVBLESHOOTING……………………………………………………………………… 31
ENGINE PRINCIPLES AND OPERATING REQUIREMENTS………………………… 32
STARTING THE ENGINE ………………………………………………………………… 32
Engine is cold …………………………………………………………………………… 32
Engine is warm…………………………………………………………………………… 32
Starting the engine after a fall or after the engine stalls……………………………… 33
Flooded engine…………………………………………………………………………… 33
Engine cold with air temperature ……………………………………………………… 33
Engine cold with air temperature above 35℃（95°F）……………………………… 33
Cold engine with air temperature below 10℃(50°F) ……………………………… 33
Engine is hot……………………………………………………………………………… 34
Starting the engine after a fall or after the engine stalls……………………………… 34
Flooded engine…………………………………………………………………………… 34
ENGINE WILL NOT START ……………………………………………………………… 35
Identifying the problem ………………………………………………………………… 35
Spark test………………………………………………………………………………… 36
Starter does not turn over or turns over slowly ……………………………………… 37
POOR ENGINE PERFORMANCE………………………………………………………… 37
Engine starts but stalls and is hard to restart…………………………………………… 37
Engine backfires, cuts out or misfires during acceleration…………………………… 37
Engine backfires on deceleration……………………………………………………… 38
Poor fuel mileage………………………………………………………………………… 38
Engine will not idle or idles roughly …………………………………………………… 38
Low engine power ………………………………………………………………………… 38
Poor idle or low speed performance…………………………………………………… 40
Poor high speed performance ………………………………………………………… 40