CLUTCH/GEARSHIFT LINKAGE
10-24
Align the cut-outs of the primary drive gear and sub-
gear as shown, then engage the primary drive/driven
gears.
Inslallthe
change clutch (1]. centrifugal clutch outer 12]
""~-J.)
~
and oil separator plate [3)
as
assembly. I'"
Install and tighten the two oil separator plate mounting
bolts \1].
Instal! the washer [1) onto the mainshaft.
Tighten the clutch lifter plate bolts [2]
10
the specified
torque.
TORQUE:12 N'm
(1
.2 kgf'm,
9lbHt)
Apply oil to the clutch
cen
ter lock nut [1] threads and
..
;;;-
..
~..,."""
seating surface.
Install the clutch center lock nut.
Hold the
clu
tch lifter plate and tighten the clutch center
lock nut to the specified torque using
the
special tools.
TOOLS:
[2] Universal holder 07725-0030000
[3]
Lock
nut
wrench
, 20 x 24
mm
07716..()020100
(4) Extension bar 07716-0020500
or
equivalent
commercially
available
in U.S.A.
TORQUE:
54
N'm
(5
.5
kgf
'm,
40
IbHt)
•
..
To Next Page