GASLAB Q2 DISPLAYS (OPERATE THE DEVICE)
Information for general use
Rev. M / 73023639
Service calibration
(3)
Base calibration
(4)
Wait for confirmations by user
Recording measurements, calibration gas 2
Wait for confirmations by user
Recording measurements, calibration gas 3
Wait for confirmations by user
Recording measurements, calibration gas 4
Wait for confirmations by user
Recording measurements, calibration gas 5
Wait for confirmations by user
Recording measurements, calibration gas 6
Wait for confirmations by user
Recording measurements, calibration gas 7
Wait for confirmations by user
Recording measurements, calibration gas 8
Wait for confirmations by user
Recording measurements, calibration gas 9
Save the calibration data
The device is not functioning correctly, see error list
If parameterized, it is possible to display another standard and switch between the standards,
therefore the appearance of the appropriate line varies, see following examples with 2 calculation
standards.
In the center is the current standard with
the standard states. In this example, it is
standard A ISO 6976 25°C 0°C.
A link to the alternatively selectable
standard appears to the right, in the
example Standard B.
Activate the link using the superimposition
keys, this will change the display as follows:
Text Main display changes to Standard B,
and indicates that the figure to the side is
displaying results using standard B.
In the middle of the second line the
standard B with the standard states is now
named in the example, it is ASTM 3588
14.696 psia.
To the right the link Standard A is shown,
which enables you to switch back again.
Figure 7.47: Examples for the appearance of the main display with 2 calculation standards
To Next Page
Loading...
