CONFIGURATION AND ANALYSIS SOFTWARE ENSUITE
Information for general use
Rev. M / 73023639
In case the certificate does not match the saved
one, enSuite will also not establish a connection
and display the certificate for validation.
This is always the case if the device
authenticates itself with a new certificate.
Click the "Stored certificate" button to display
the previous certificate and compare it with the
current one.
Figure 8.9: Changed certificatet
► Check the validity of the certificate. You have the following options:
Check the certificate on the device on site
Open the certificate information via the basic display of the device:
Info – <device serial no.>, Certificate
Compare the fingerprint and enSuite information under the Subject with the information
printed on the device.
Remotely verify certificate
(Without a connection, you won't be able to compare the fingerprint, so...)
...first check the information on the device in the section Subject of the dialog
If the information is correct, establish a temporary connection to the device,
as described below
To Next Page
Loading...
Need help?
General
