If you wish to view a calculated value, for example the inferior calorific value, you can display all three
different states of the gas (completely dry/completely wet/partly wet).
When you have dragged the required values from the right-hand window into the center, simply click
on “Poll” and you will see values updated every second while the button changes to “Suspend”. If
you click on “Snapshot”, the current value will be frozen and can be viewed in a new table sheet
created at the same time.
Figure 8.51: Snapshot tab
If you click on “Full precision”, the display of the values will be extended to all the existing decimals.
If you click on “Remove all”, the display window in the center will be cleared. Other examples include
the following:
• Use as “Device monitor” to obtain information about the operating hours and
battery charge and the CPU and RAM load. These data can be opened if the
export values from “Device status” are used in the tab.
• Use as “Time Service display” to provide information about the time setting
and events and data linked to it. This information can be opened if the export
values from “Time service” are used.
To Next Page
Loading...
Need help?
General
