Examples of application tab “Dynamic charts”
Here you can select values which you wish to see in graphic form. To do so, drag the values from the
right-hand window into the central area.
Please remember that these must be “Groups” (see above) if you want to display more than 2 values.
Once the required values have been positioned in the center window, click again on “Poll”. The
values will then be displayed in a line diagram.
The button will change to “Suspend” (as shown below) and “freezes” the graphs when it is clicked
until fresh values are displayed by clicking on “Poll”.
Figure 8.52: Tab “Dynamic chart”
You can clear the central section again by clicking on “Remove all” and display other values in
graphic form.
The number values form the Y-axis, while the recording time is shown as the X-axis.
To Next Page
Loading...
