Prepare the hoses, cables, and leads
Before you install the hoses, cables, and leads, uncoil and examine them.
1. Use a hand-over-hand motion to uncoil the hoses, cables, and leads.
Keep the flat part of each hose, cable, or lead on the floor as you uncoil it. Do not pull from one end to
uncoil.
NOTICE
PULLING FROM ONE END TO UNCOIL HOSES, CABLES, AND LEADS CAN CAUSE
DAMAGE.
To avoid equipment damage, do not pull from one end to uncoil hoses, cables, and leads.
2. Make sure that you have the correct hoses, cables, and leads.
New hoses, cables, and leads ship with a tag or label that has a part number for identification. Do not
order or use cables, hoses, or leads that are incorrect or longer than necessary. If you coil a cable or
lead because it is too long, EMI problems can occur. EMI problems can have a bad effect on system
performance.
Installation
3
105811530Instruction ManualXPR460
To Next Page
Loading...
