Hypertherm XPR460 - Connect the Cooler

Figure 25 - Connections complete on the rear of the plasma power supply
1
2
3
4
5
5
6
6
7
7
1 Coolant supply, green and coolant return, red
2 Power cable, 220 VAC, to the cooler
3 CAN cable to the cooler
4 Power cable, 120 VAC, to the gas connect console
5 Pilot-arc cable to the gas connect console
6 Negative cables to the gas connect console
7 Work cables to the cutting table
Connect the cooler
Use this information to connect the hoses, cables, and leads to the cooler.
Before you begin:
■
Put the plasma power supply in position on page 91
■
Ground the system components on page 98
Installation
3
111811530Instruction ManualXPR460