3. Examine each hose, cable, and lead for damage.
Equipment damage can have a bad effect on system performance.
Speak to your cutting machine supplier or regional Hypertherm
Technical Service team.
Connect the plasma power supply
Use this information to connect the hoses, cables, and leads to the plasma power supply.
Before you begin:
■
Put the plasma power supply in position on page 91
■
Ground the system components on page 98
■
Prepare the hoses, cables, and leads on page 105
■
Refer to the label that shows the symbols and connectors on the rear of the plasma power supply.
Figure 22 - Example label that shows the symbols and
connectors on the rear of the plasma power supply
Installation
3
106
811530 Instruction Manual XPR460
To Next Page
Loading...
