For information about how to use the CNC to control cutting system operation, refer to:
■
The instruction manual for your CNC
■
CNC Communication Protocol for the XPR Cutting System (809810)
Wireless device controls
You can use a wireless device to set up and monitor the plasma cutting system.
A wireless device with the XPR web interface sends commands to the XPR cutting system through a
wireless connection between the wireless device and the plasma power supply.
Some cutting system commands, settings, and displays can be seen and controlled from different XPR
web interface screens. For information on these screens, refer to Web interface screen information on
page 188.
For information about how to set up a wireless device with the XPR web interface, refer to Requirements
for the XPR web interface on page 168.
Power-indicator LEDs
An LED illuminates to show the power status on the plasma power supply and on other system
components.
The power-indicator LED on the plasma power supply uses two colors to indicate power status:
■
The LED illuminates amber when the plasma power supply is receiving electric power and the remote
on-off switch or redundant remote on-off switch is in the OFF position.
■
The LED illuminates green when the plasma power supply is receiving electric power and the remote
on-off switch or redundant remote on-off switch is in the ON position.
Figure 56 - Power-indicator LED on the plasma power supply
When illuminated, the green power-indicator LED on other components is an indication that:
■
Power is supplied to the XPR cutting system.
■
The line-disconnect switch or breaker for the component is set to the ON (I) position.
Operation
6
216
811530 Instruction Manual XPR460
To Next Page
Loading...
