5. Wait 30 seconds.
6. Remove the power from the cutting system:
a. Set the line-disconnect switch to the OFF position.
b. Make sure that the power-indicator LED on the plasma power supply is not illuminated.
7. On the main control PCB, set position 4 on DIP switch S3 to the OFF position.
This enables the wireless connection.
8. Install the control-side panel of the plasma power supply.
9. Supply power to the cutting system:
a. Set the line-disconnect switch to the ON position.
b. Make sure that the power-indicator LED on the plasma power supply is illuminated.
10. Wait 60 seconds.
The wireless module is now set to the factory default settings.
Disable the wireless connection temporarily
If you want to disable the wireless connection temporarily, use this procedure.
Before you begin:
WARNING
ELECTRIC SHOCK CAN KILL
The plasma power supply contains dangerous electric voltages that
can seriously injure or kill you. Even if the plasma power supply is
turned OFF, you can still get a serious electric shock if the plasma
power supply remains connected to an electric power source.
Use extreme caution if you do diagnosis or maintenance tasks when
the plasma power supply remains connected to an electric power
source and the outer cover or panels are removed. All work that
requires removal of the plasma power supply outer cover or panels
must be done by a qualified technician. Refer to the Safety and
Compliance Manual (80669C) for more safety information.
Connect for Communication
4
185811530Instruction ManualXPR460
To Next Page
Loading...
