b. Make sure that the power-indicator LED on the plasma power supply is not illuminated.
2. Remove the control-side panel of the plasma power supply.
3. On the main control PCB, set position 4 on DIP switch S3 to the ON position.
This disables the wireless connection.
4. Supply power to the cutting system:
a. Set the line-disconnect switch to the ON position.
b. Make sure that the power-indicator LED on the plasma power supply is illuminated.
WARNING
ELECTRIC SHOCK CAN KILL
The plasma power supply contains dangerous electric voltages that can
seriously injure or kill you.
Use extreme caution if you do service or maintenance work on a plasma power
supply when it is connected to an electric power source and the outer cover or
panels are removed.
Connect for Communication
4
184
811530 Instruction Manual XPR460
To Next Page
Loading...
