Hypertherm XPR460 - Put the Torchconnect Console in Position

Figure 13 - Mounting-hole locations and dimensions for the OptiMix gas connect console
1 Gas-inlet side
2 Gas-outlet side
* Correct orientation. Never install the gas connect console at an angle.
Put the TorchConnect console in position
There are three options to put the TorchConnect console in position. The factory-installed location for the
mounting brackets is on the bottom panel of the console. But, you can move the brackets to the end or to
the side.
Installation
3
95811530Instruction ManualXPR460