Before you begin:
■
Requirements to put system components in position on page 61
■
Worksite requirements for system components on page 65
■
A side position with the torch-lead connector on the bottom minimizes the risk that leaked water or
coolant will accumulate in the console. Water or coolant in the console can damage internal electrical
components.
■
A side position with the torch-lead connector on the top makes it necessary to install a support that
holds the lead at a minimum bend radius of 15.25 cm (6 in.).
1. Put the TorchConnect console in a position that obeys requirements for your cutting system
configuration.
If you have questions about what position to use or how to install the console, speak to your cutting
machine supplier or regional Hypertherm Technical Service team.
2. Use the mounting brackets on the bottom, end, or side panel of the TorchConnect console to put the
console in position, as shown.
The following images show the three options to put the TorchConnect console in position:
Figure 14 - The three options to put the TorchConnect console in position
1 Bottom
2 End
3 Side
Installation
3
96
811530 Instruction Manual XPR460
To Next Page
Loading...
