Hypertherm XPR460 - Lifting Equipment; Put the Cooler in Position

WARNING
HEAVY EQUIPMENT CAN CAUSE SERIOUS INJURY IF DROPPED –
LIFT CAREFULLY
When lifting or moving a heavy component:
■
Remove all cables, wires, and other potential obstacles that can get caught on
the component.
■
Only use lift equipment that can safely lift and support the component.
■
If you use the lift eye to lift the component, lift only that component. Do not
exceed the maximum lift-eye rating.
■
If you use a lift truck, use one with forks that extend along the entire bottom of
the component. The bottom of the component has lift-truck slots. Make sure to
use them.
■
Carefully put when you put the plasma power supply into position. Do not drop
it from any height.
1. Make sure that the equipment you use to lift and move heavy system components has these features
and capabilities:
Lift truck forks Lift truck forks must be long enough to fully support and extend along the
entire bottom of the system component and rated to hold its weight.
Lifting equipment Lifting equipment must be rated to hold the weight of the system compo-
nent.
2. Use approved equipment with slow speeds to balance, lift, move, and put the plasma power supply
in a position that obeys requirements for your cutting system configuration and plasma power supply
type.
Put the cooler in position
The cooler weighs 83.46 kg (184 lb). It must be lifted and moved with care to avoid injury or damage.
Before you begin:
■
Requirements to put system components in position on page 61
■
Worksite requirements for system components on page 65
Installation
3
92
811530 Instruction Manual XPR460