Hypertherm XPR460 - Example of Internal Ohmic Contact Sense

If no... Go to the next step.
5. Connect the ohmic wire from the ohmic relay to J4 pin 2 on the ohmic PCB in the TorchConnect
console.
6. Connect the ohmic wire to the PCB connection for ohmic inside the torch lifter.
Refer to Example of external ohmic contact sense on page 200.
Example of internal ohmic contact sense
Internal ohmic contact sense is the default installation for the torch and the TorchConnect console. No
more steps are necessary.
Figure 54 - Example diagram of internal ohmic contact sense
Connect for Communication
4
199811530Instruction ManualXPR460