Web interface support information
■
If you have a problem connecting and you think it is a problem with your device, router, or local
network, speak to your system administrator.
■
If you have a problem connecting and you think it is a problem with the plasma power supply, speak to
your cutting machine supplier or regional Hypertherm Technical Service team.
Use AP mode to connect
In AP mode, each plasma power supply has its own connection. You can only connect to and control one
plasma power supply at a time.
Before you begin:
■
Computer-based device with a screen
■
Web browser that has support for the latest web standards
■
Wireless access
1. Supply power to the cutting system:
a. Set the line-disconnect switch to the ON position.
b. Make sure that the power-indicator LED on the plasma power supply is illuminated.
c. Make sure that the remote on-off switch for the plasma power supply is set to ON.
d. If the redundant remote on-off switch is installed, make sure that it is set to ON.
2. On your device, go to the wireless connections menu.
This menu can be different on different devices.
3. Choose the XPR connection.
The default connection name is "xpr" + the System ID. The System ID is the last four digits of the
Media Access Control (MAC) address. For more information about the System ID and MAC address,
refer to Web interface screen information on page 188.
If you want to change the connection name, refer to Other screen on page 196.
Connect for Communication
4
169811530Instruction ManualXPR460
To Next Page
Loading...
