4. Enter the password hypertherm.
If you want to change the connection name, refer to Other screen on page 196.
5. Open a web browser.
6. Go to 192.168.1.1/index.html.
7. To fully operate the cutting system, you must also use discrete.
Refer to Connect to the plasma power supply with discrete on page 162.
■
The plasma power supply is now connected.
■
The information about your plasma power supply and connection are located in the top left of the XPR
web interface.
■
If the Client ID and the Operator ID are the same on your device, you are in control of the plasma
power supply and can set a process.
■
Refer to Web interface screen information on page 188 for more information about the interface
menus.
Connect for Communication
4
170
811530 Instruction Manual XPR460
To Next Page
Loading...
