Hypertherm XPR460 - Requirements for the XPR Web Interface

Requirements for the XPR web interface
You can connect to the XPR web interface through Wi-Fi with AP mode or with network mode.
NOTICE
WEAK NETWORK SECURITY INCREASES THE RISK FOR UNAUTHORIZED CUTTING
SYSTEM OPERATION OR MISUSE
If you use a wireless (Wi-Fi) network to communicate with your cutting system, Hypertherm
recommends the use of a secure Wi-Fi network to minimize the risk of unauthorized cutting system
operation or misuse. Unauthorized access or misuse of the Wi-Fi network can result in incorrect
settings or commands. Bad settings and commands can cause an uncontrollable or unusable
system. A bad effect on system performance, shortened consumable life, and torch damage is also
possible. Minimum security features can include, but are not limited to, the following:
■
Password protection
■
WPA2 security for the plasma power supply
■
A hidden Service Set Identifier (SSID) for the Wi-Fi network
■
Operator training about network security
You must use discrete with the XPR web interface to operate the cutting system.
If you go out of range with the device, you cannot communicate with
the cutting system. The cutting system continues to operate. For more
information about distances for wireless, refer to Distance requirements
for communications on page 69.
Hypertherm recommends a minimum distance of 1 meter (3.3 feet) between the plasma power supply and
other system components, or between the plasma power supply and an obstacle.
You can use one of the following options to connect to the XPR web interface through Wi-Fi:
■
AP mode. Refer to Use AP mode to connect on page 169.
□
You connect to the same network as the plasma power supply.
□
AP mode is the default connection option. You connect to a single plasma power supply.
■
Network mode. Refer to Use network mode to connect on page 171.
□
You connect the plasma power supply to your network.
□
The advantage of network mode is that you can connect to one network to get access to
multiple plasma power supplies.
Connect for Communication
4
168
811530 Instruction Manual XPR460