3
Installation
79811530Instruction ManualXPR460
3Installation
Before you begin installation
Before you begin installation, make sure to:
■
Read, understand, and obey all of the safety instructions that are in this manual, the Safety and
Compliance Manual (80669C), the Radio Frequency Warning Manual (80945C), and affixed to the
cutting system. Failure to follow safety instructions can result in personal injury or equipment damage.
■
Get all necessary reference documents. Refer to Document requirements on page 41.
■
Understand and obey the following requirements when planning where to put system components:
□
Worksite requirements for system components on page 65
□
Length requirements for hoses, cables, and leads on page 66
□
Bend-radius requirements for hoses, cables, and leads on page 66
□
Distance requirements between high-frequency cables and control cables on page 68
□
Distance requirements for ventilation and access on page 68
□
Distance requirements for communications on page 69
■
Understand and obey all applicable national and local codes and system requirements:
□
Electrical codes and requirements on page 44
□
Process-gas requirements for all gas connect consoles on page 48
□
Plumbing requirements for supply gases on page 50 and Regulator requirements for supply
gases on page 53
□
Shield-water requirements (VWI and OptiMix) on page 55
□
Recommended grounding and shielding on page 72
This plasma system can make more than the permitted acoustical noise levels as defined by national
and local codes. Always put on correct ear protection when cutting or gouging. Any acoustical noise
To Next Page
Loading...
