Hypertherm XPR460 - Requirements to Put System Components in Position; Configuration with the Core Gas Connect Console

Requirements to put system components in position
When planning where to put the plasma power supply, gas connect console, TorchConnect console,
cooler, and torch, consider the following limitations and requirements:
■
Worksite requirements for system components on page 65
■
Length requirements for hoses, cables, and leads on page 66
■
Bend-radius requirements for hoses, cables, and leads on page 66
■
Distance requirements between high-frequency cables and control cables on page 68
■
Distance requirements for ventilation and access on page 68
■
Distance requirements for communications on page 69
Configuration with the Core gas connect console
A Plasma power supply
B Cooler
C Gas connect console (Core)
D TorchConnect console
E Torch
F Cutting table
G CNC
1 CNC lead
2 Work cables
3 Controller Area Network (CAN) cable
Qualifications and Requirements
2
61811530Instruction ManualXPR460