Critical raw material Components that contain more than 1 gram
Silicon metal Heatsinks, cold plates, transformers, inductors, Insulated-gate Bipolar Transistor
(IGBT) modules
Tantalum Capacitors
Tungsten Power resistors
Safety and EMC symbols and marks
You can see different safety and EMC symbols and marks on your system. Each image identifies a specific
regional certification.
Your product may have one or more of the following marks on or near the data plate. Because of
differences and conflicts in national regulations, not all marks are applied to every version of a product.
S mark
The S mark indicates that the power supply and torch are suitable for operations
carried out in environments with increased hazard of electrical shock according to IEC
60974-1.
CSA mark
Products with a CSA mark meet the United States and Canadian regulations
for product safety. The products were evaluated, tested, and certified by CSA-
International. Alternatively, the product may have a mark by one of the other Nationally
Recognized Testing Laboratories (NRTL) accredited in both the United States and
Canada, such as UL or TÜV.
CE mark
The CE marking signifies the manufacturer’s declaration of conformity to applicable
European directives and standards. Only those versions of products with a CE
marking located on or near the data plate comply with European Directives.
Applicable directives may include the European Low Voltage Directive, the European
Electromagnetic Compatibility (EMC) Directive, the Radio Equipment Directive (RED),
and the Restriction of Hazardous Substances (RoHS) Directive. See the European
CE Declaration of Conformity for details.
Specifications
1
38
811530 Instruction Manual XPR460
To Next Page
Loading...
