Hypertherm XPR460 - Qualifications of Service Personnel

Qualifications of service personnel
It can be hazardous to do service and maintenance on industrial cutting systems and equipment.
WARNING
ELECTRIC SHOCK CAN KILL
The plasma power supply contains dangerous electric voltages that
can seriously injure or kill you. Even if the plasma power supply is
turned OFF, you can still get a serious electric shock if the plasma
power supply remains connected to an electric power source.
Use extreme caution if you do diagnosis or maintenance tasks when
the plasma power supply remains connected to an electric power
source and the outer cover or panels are removed. All work that
requires removal of the plasma power supply outer cover or panels
must be done by a qualified technician. Refer to the Safety and
Compliance Manual (80669C) for more safety information.
For your safety and for the best results:
■
Always read, understand, and follow all of the safety instructions in this manual, the Safety and
Compliance Manual (80669C), and on the labels that are on the cutting system.
■
Get adequate training from a knowledgeable source before you do any service or maintenance on the
cutting system or equipment.
The entity responsible for workplace safety where your XPR cutting
system is used must do a risk assessment and establish the criteria
for service personnel training and qualifications.
■
Do not do any service or maintenance on the cutting system or equipment if you cannot follow all of
the safety instructions or if you cannot satisfy the minimum service-personnel qualifications set by
workplace safety at your organization. Refer to the Safety and Compliance Manual (80669C), Radio
Frequency Warning Manual (80945C), and Before you begin installation on page 79.
■
Contact a professional repair person who has a license.
Qualifications and Requirements
2
43811530Instruction ManualXPR460