Hypertherm XPR460 - Change the Device that Has Control

Connect
On this screen you can change your client settings and connect to other networks. For information
about how to do this, refer to Use network mode to connect on page 171.
Update
On this screen you can update the web interface and firmware. For information about how to do
this, refer to CNC Communication Protocol for the XPR Cutting System (809810) .
Figure 53 - Example of an Other screen
The XPR web interface shows different fields for different models. The
screen shown is for reference only.
Change the device that has control
Use these steps to make sure that the correct device has control of the plasma power supply.
The device that first sets a process controls the plasma power supply. For example, if the CNC sets the
process, all other devices that connect to the plasma power supply after the CNC sets the process can
only monitor the data.
Connect for Communication
4
197811530Instruction ManualXPR460