10
Wiring Diagrams
439811530Instruction ManualXPR460
10Wiring Diagrams
Wiring diagram conventions
When you look for a signal path on the wiring diagrams, use the following conventions to find the path
where it continues on a different sheet or at a different location on the same sheet:
■
Sheet numbers are in the lower right corner of each sheet.
■
References to other locations use the following connection symbol and conventions.
Use the sheet number to find the reference sheet. Align the coordinates A–D on the Y axis with the
numbers 1–4 on the X axis of each sheet to find the reference blocks (similar to a road map).
1 Sheet number
2 Coordinates
3 Reference block
Wiring diagram symbols
These symbols are used in the wiring diagrams to represent elements of the plasma cutting system and
torch.
Battery Ground clamp Receptacle
Cap, polarized Ground, chassis Relay, coil
Cap, not polarized Ground, earth Relay, normally
closed
To Next Page
Loading...
