Install the torch-lead assembly to the torch receptacle
Use this information to install the torch-lead assembly to the torch receptacle. For easier installation, make
sure that the connections are done in the same sequence as these steps.
1. Unwind approximately 2 meters (6.5 feet) of the torch-end of the torch-lead assembly.
2. Put the torch collar on the connector-end of the torch.
3. Put the torch mounting sleeve on the torch-end of the torch-lead assembly.
Adjust the mounting sleeve as necessary for good access to the connector ends.
4. Align the connectors in the torch-lead assembly and the torch receptacle.
1 Pilot arc
2 Ohmic
3 Coolant return
4 Plasma valve
5 Plasma Line A, black
6 Coolant supply, green
7 Shield gas, blue
8 Plasma Line B, yellow
Installation
3
136
811530 Instruction Manual XPR460
To Next Page
Loading...
