You can customize some parameters by choosing the + to open the menu. The plasma power supply
keeps this customization until the remote on-off switch is set to OFF or the power is removed from the
plasma power supply. The customization is also reset when you select a new process.
Figure 52 - Example of an Operate screen
Other screen
On this screen you can see the software versions and monitor the status of the wireless connection. You
can also select the Configure, Connect, and Update commands.
Configure
On this screen you can change the connection name, limited AP password, limited AP IP address,
or the setup password.
■
You cannot use special characters in any of the fields on this screen.
■
The connection name must be less than 32 characters long.
■
Passwords must be between 8 – 20 characters long.
■
Passwords are case sensitive.
Connect for Communication
4
196
811530 Instruction Manual XPR460
To Next Page
Loading...
