NOTICE
FOR THE BEST CUT QUALITY AND CONSUMABLE LIFE USE THE CORRECT LEAD
LENGTHS
Cut quality and the lifespan of consumables will be decreased if you change the lead lengths.
The manufactured lengths of torch and console leads are critical for system performance. Never
change the lengths of leads.
Installation checklist
This checklist summarizes major installation steps. You can use it to record their completion. For full
information, refer to Installation steps on page 91.
☐
Put the system components in position.
☐
Plasma power supply
☐
Cooler
☐
Gas connect console
☐
TorchConnect console
☐
Torch
Refer to Configuration with the Core gas connect console on page 61, Configuration with the
CorePlus gas connect console on page 62, or Configuration with VWI or OptiMix gas consoles on
page 63.
☐
Ground the system components.
☐
Plasma power supply
☐
Cooler
☐
Gas connect console
☐
TorchConnect console
☐
Torch lead collar
☐
Cutting table
☐
CNC
Before you connect hoses, cables, and leads, make sure that all system components are correctly and
fully grounded. Refer to Recommended grounding and shielding on page 72.
☐
Connect all of the hoses, cables, and leads to the plasma power supply.
Installation
3
84
811530 Instruction Manual XPR460
To Next Page
Loading...
