7
Maintenance
247811530Instruction ManualXPR460
7Maintenance
Plasma system maintenance
Hypertherm cutting systems can operate in harsh conditions for many years. To maintain cutting system
performance, minimize operating costs, and lengthen cutting system life, it is important to follow all
maintenance procedures and schedules.
If you have questions about how to maintain your cutting system, contact your cutting machine supplier or
regional Hypertherm Technical Service team. You can find contact information for your regional office at
www.hypertherm.com on the "Contact us" page.
This section of the manual describes maintenance steps that you must do daily, before system
operation.
■
For instructions about preventive maintenance (such as weekly, monthly, and yearly tasks) refer to the
XPR Preventative Maintenance Program (PMP) Instruction Manual (809490).
■
For recommendations about how to diagnose and troubleshoot performance issues, refer to
Diagnostics and Troubleshooting.
■
For PCB drawings and LED locations, refer to Plasma power supply power distribution PCB (141577)
diagram on page 381.
Refer to this table for a list of preventive maintenance steps. The XPR Preventative Maintenance Program
(PMP) Instruction Manual (809490) explains how to do them.
Usually, operators can do the daily, weekly, and bi-monthly tasks, but qualified maintenance personnel are
needed for monthly, every-6-month, and yearly tasks.
To Next Page
Loading...
