5. Choose Apply Settings.
6. Remove the power from the cutting system.
7. Supply power to the cutting system.
The change goes into effect after you remove and then supply power to the cutting system.
Change the limited AP settings
You can change the limited AP SSID, channel, and security settings in the Connect screen.
1. On the Device Setup screen, choose Network > ap0 > Link > Configuration.
2. On the Configuration screen, change the settings.
3. Make sure that all of the settings are correct, then choose Submit to save and apply them.
4. Remove the power from the cutting system.
5. Supply power to the cutting system.
Connect for Communication
4
180
811530 Instruction Manual XPR460
To Next Page
Loading...
