Hypertherm XPR460 - Torchconnect Console Description; Cooler Description

OptiMix gas connect console, there is also a gas mixer that has its own control PCB. A green power LED
illuminates when power is supplied to the console.
For some cutting systems, a remote on-off switch and redundant remote
on-switch (if enabled) control the power that goes to the console.
The CorePlus gas connect console has many of the same features as the Core console. The primary
difference is that CorePlus adds a gas line for Argon.
TorchConnect console description
The TorchConnect console supplies all power, gas, and cooling connections for connection to the torch.
The TorchConnect console has proportional valves, solenoid valves, and pressure transducers. The
TorchConnect console also has a control PCB and an ohmic contact PCB. A power-indicator LED
illuminates when power is supplied to the console.
For some cutting systems, a remote on-off switch controls the power that
goes to the console.
Cooler description
The cooler is a requirement for cutting system operation. It contains a heat-exchanger and two fans and
supplies coolant to the liquid-cooled components of the cutting system.
NOTICE
LOW COOLANT LEVELS CAN DAMAGE THE CUTTING SYSTEM AND COOLANT PUMP
There is a risk of serious damage to the cutting system and to the coolant pump if you operate
the cutting system with no coolant or with low coolant. If your coolant pump is damaged, pump
replacement can be necessary.
Never operate the cutting system if you get a low coolant level notice.
Inside of the cooler are the following components:
■
Reservoir
■
Pump
■
Flow meter
■
Filter for coolant
■
Heat exchanger
Specifications
1
29811530Instruction ManualXPR460