The torch head that comes with the XPR torch assembly kit (10083906) has 460 A mild steel
consumables pre-installed.
☐
Install the torch into the torch receptacle.
Refer to Install the torch into the torch receptacle on page 145.
☐
Connect electric power to the cutting system on page 151.
☐
Make sure that the communication method for the CNC interface is installed correctly.
☐
EtherCAT and remote on-off with discrete
Refer to Connect to the plasma power supply with EtherCAT on page 155.
☐
Wireless (XPR web interface) and discrete
☐
Serial RS-422 and discrete
☐
Remote on-off must be wired discretely by the cutting system manufacturer.
A feature of the control PCB is that it offers redundancy to the standard remote on-off switch. If
redundant remote-on off is enabled, the switches for both the standard and redundant remote on-
off must be set to ON to supply electric power to the cutting system. Refer to Install a redundant
remote on-off switch on page 207.
☐
Install the coolant.
☐
Refer to Fill the cutting system with coolant on page 209.
☐
Make sure that the coolant type is correct.
Refer to Coolant requirements on page 57.
☐
Make sure that the coolant reservoir is full.
Configuration with Core gas connect consoles
Installation
3
87811530Instruction ManualXPR460
To Next Page
Loading...
