■
The component can be used.
Figure 57 - Power-indicator LED locations on other components
Sequence of operation
A set of flowchart images shows the sequence of operation for the plasma cutting system.
Each state of operation is given a unique name and number so that it can be identified. The type of name
that you see (name or number) is specified in your cutting system settings.
Power-up state (1)
The Power-up state (1) process starts when the operator sets the remote on-off switch for the plasma
cutting system to the ON position.
Operation
6
217811530Instruction ManualXPR460
To Next Page
Loading...
