Access the XPR web interface after setup in network mode
Use these steps to access the XPR web interface using the IP address of the plasma power supply.
Before you begin: Hypertherm recommends that you use Dynamic Host Configuration Protocol (DHCP)
reservation if it is available on your router. This lets the plasma power supply keep the same IP address
through power cycles without having to set up the wireless module with the static IP address.
1. On the Device Setup screen, choose Status.
2. Look in the Interface wlan0 fields on the Status screen to find the IP address that you want.
Connect for Communication
4
178
811530 Instruction Manual XPR460
To Next Page
Loading...
