■
If you are monitoring with the XPR web interface, you are done.
■
The selected wireless settings are applied to connect the plasma power supply to the new network.
The plasma power supply resets and connects to the new network.
What to do next:
■
If you want to operate the cutting system, you must connect to the plasma power supply with discrete.
Refer to Connect to the plasma power supply with discrete on page 162.
■
To access the web interface through Wi-Fi after setup, go to Access the XPR web interface after
setup in network mode on page 178.
Connect for Communication
4
177811530Instruction ManualXPR460
To Next Page
Loading...
