Hypertherm XPR460 - Set up the Wireless Network Manually

■
The network is now connected.
■
If you are monitoring with the XPR web interface through Wi-Fi, you are done.
What to do next: If you want to operate the cutting system, you must connect to the plasma power supply
with discrete. Refer to Connect to the plasma power supply with discrete on page 162.
Set up the wireless network manually
Use these steps to set up a wireless network manually.
1. On the Device Setup screen, choose WLAN Profiles.
2. In the WLAN Profile Management field, enter a name for the profile you want to create, and choose
Apply.
Connect for Communication
4
175811530Instruction ManualXPR460