Hypertherm XPR460 - Put the Gas Connect Console in Position

WARNING
HEAVY EQUIPMENT CAN CAUSE SERIOUS INJURY IF DROPPED –
LIFT CAREFULLY
When lifting or moving a heavy component:
■
Remove all cables, wires, and other potential obstacles that can get caught on
the component.
■
Only use lift equipment that can safely lift and support the component.
■
If you use the lift eye to lift the component, lift only that component. Do not
exceed the maximum lift-eye rating.
■
If you use a lift truck, use one with forks that extend along the entire bottom of
the component. The bottom of the component has lift-truck slots. Make sure to
use them.
■
Carefully put when you put the plasma power supply into position. Do not drop
it from any height.
1. Make sure that the equipment you use to lift and move heavy system components has these features
and capabilities:
Lift truck forks Lift truck forks must be long enough to fully support and extend along the
entire bottom of the system component and rated to hold its weight.
Lifting equipment Lifting equipment must be rated to hold the weight of the system compo-
nent.
2. Use approved equipment with slow speeds to balance, lift, move, and put the cooler in a position that
obeys requirements for your cutting system configuration.
Coolant in the reservoir changes weight distribution for the cooler. After coolant installation, the cooler
can tilt or move from coolant weight and movement.
Put the gas connect console in position
All gas connect consoles have three mounting holes on the bottom panel.
Before you begin:
■
Requirements to put system components in position on page 61
Installation
3
93811530Instruction ManualXPR460